Page 1 of 1
Removing formatting with DBSRichViewEdit1
Posted: Wed Jan 25, 2012 12:17 pm
by alexandreq
Hello Friend,
I am using your function to remove all formatting.
When I did it, I notice that it was done only on the screen.
How to save this changed in table with the text?
thanks
Posted: Thu Jan 26, 2012 7:59 pm
by Sergey Tkachenko
See
http://www.trichview.com/help/idh_examp ... edit1.html
Insert your code for clearing text format instead of
Code: Select all
DBRichViewEdit1.Clear;
DBRichViewEdit1.LoadRTF(OpenDialog1.FileName);
Posted: Fri Jan 27, 2012 10:22 am
by alexandreq
Sergey
But my text comes from my table and not from a file.
I used your function and all my text was clear. But the problem is that my table didn't be in state of dsEdit after cleaning all the formating of the text.
did you understand?
Posted: Sat Jan 28, 2012 11:37 am
by Sergey Tkachenko
Use this code:
Code: Select all
if DBRichViewEdit1.CanChange then begin
<your code for clearing formatting here>
DBRichViewEdit1.Change;
DBRichViewEdit1.Format;
end;
Or, if you want to save changes immediately:
Code: Select all
if DBRichViewEdit1.CanChange then begin
<your code for clearing formatting here>
DBRichViewEdit1.Change;
Table1.Post;
end;
DBRichViewEdit1.CanChange activates table editing, it makes table state = dsEdit
Posted: Sun Jan 29, 2012 10:16 pm
by alexandreq
thanks very much.
It worked fine