Install issue via XE2

[tonzo.mouse]

Hi,

I tried to install the TRichView.v.17.03.0 on XE2.
so i use the IDEInstall.exe in the folder Setup and choose the file TRichViewFullDelphi.iide to instll it.
But it failed.
And I got a error message like this:

error mes

err.jpg (125.85 KiB) Viewed 19165 times

So what can i do next?

[Sergey Tkachenko]

Very strange. "path written by the installer" is the initial value of the Files in the section [Install] in the configuration files.
But the installer must replace it with the actual value. Normally, the actual value is a corresponding environment variable.
For TRichView full version, it must be

Code: Select all

Files=%TRichViewVCL

Open <TRichView Dir>\Setup\TRichViewFullDelphi.iide and make this correction.

[tonzo.mouse]

Hi Sergey,

I modified the Files section to "Files=%TRichViewVCL" in the file of TRichViewFullDelphi.iide.

But when i tried to install the trichview again, i got a new wrong message:

Not Defined.jpg (8.07 KiB) Viewed 19148 times

[Sergey Tkachenko]

This variable is created by the installer.

Did you run the installer (not IDEInstall, but the installer that unpacks files)?

[tonzo.mouse]

I check out my folders, but no file named installer found.

i got these files like this:

fls1.jpg (16.23 KiB) Viewed 19111 times

And only IDEInstall.exe in the folder Setup

ins.jpg (9.89 KiB) Viewed 19111 times

[Sergey Tkachenko]

Where did you get these files from? Normally, they are unpacked by the installer, named TRichViewSetup-17.exe or like this.